The E58 RS Low Pitch Roof Tile

The Erlus E58 RS is purpose-built for low-pitch roofs where performance is critical. Thanks to its deep, precision-engineered interlocking channels, the tile can be installed at pitches as low as 10°, significantly lower than standard pantiles. Its advanced design actively directs water away from the roof surface, ensuring fast, controlled drainage even on shallow slopes on long rafter lengths. The pronounced interlocking profile, featuring triple head and side locks, creates a highly secure barrier against water ingress.

Erlus E58 RS Low Pitch Roof Tile in Copper Brown

E58 RS Data Sheet

Dimensions

Length 465 mm

Width 285 mm

​Minimum Pitch

10°

Roofs between 10° - 20° should use a 330g/m² underlay laid to boards, counter battens laid over PUR Nail sealing Tape and each tile must be clipped.

Please refer to our technical department for guidance

​Pieces per m2

12.5

Individual tile weight

4.25 Kg

​Batten Gauge

360 - 366mm 

​​Cover Width

219mm (+2/-2mm)

​Weight per m2 laid

53 kg / m2

gold badge image

Low Pitch Specification

For verge to verge and lean to roofs with Rafter pitches between 10°-16°, and a maximum rafter length of 10 metres.
The roof structure should be fully boarded using suitable timber decking. A continuous layer of Stoneleaf Sovereign 330g/m2 underlay installed over the decking, with all laps sealed using the integrated tape.
Install Counter battens 38×50mm, vertically over the underlay at centres not exceeding 600 mm. Counter battens to be installed over a self-sealing tape ensuring all fixings are sealed against water ingress.
Tile battens of 25×50mm are then be fixed horizontally to the counter battens in accordance with the required gauge for Karat RS tiles, ensuring that each tile is securely clipped.
Adequate ventilation shall be provided at both the eaves and the ridge (or top edge), as per diagrams below: